Filter
Top Products
2
2-5GFK-0804B Chapter 2 Programming with the Programming Software
Running the Programming Software
The programming software can be run from diskette, or installed on a hard disk. For
installation instructions and information about the files on the software diskette, refer to
the Micro PLC User’s Guide (GFK-0803).
Running the Programming Software from a Hard Disk
1. Go to the directory where you placed the MICRO.EXE file. For example:
C:>CD MICRO (Press the Enter key)
2. To run the programming software, type:
C:\MICRO>MICRO (Press the Enter key)
Running the Programming Software Directly from a Diskette
1. Go to the DOS prompt if it is not already displayed:
A:>
2. Place the diskette containing the programming software into the appropriate
diskette drive (for example, drive A). To run the programming software, type:
A:>MICRO (Press the Enter key)
3. Place a formatted diskette into drive B. You can use this diskette for storing
configuration files.