Filter
Top Products
8 - 21
MELSEC-
A
8 OTHER FUNCTIONS
(4) Program
The following shows the program for registration to the E2PROM of the R2.
The following program assumes that the buffer memory automatic update
function is used.
Refer to Section 5.1 for program conditions.
(a) When using the FROM/TO command with the ACPU / QCPU-
A (A mode)
Registration execution
Pulsate registration
execution signal
Change to bank 2
Change to bank 0
Write "0" in to
register (default value is "4"
)
Set EEPROM function
request (RYn7)
Reset EEPROM function
request (RYn7)
R2 1C0
H
1) Program to change to bank 0
Specify partial refresh
Specify bank 0
Execute partial refresh
2) Program to change to bank 2
Specify partial refresh
Specify bank 2
Execute partial refresh