Filter
Top Products
9 - 43
MELSEC-
A
9 PROGRAM EXAMPLES
9.3.3 When using dedicated commands with QCPU (Q mode) / QnACPU
An example of the program for using the dedicated commands with the QCPU (Q
mode) / QnACPU when using the transmission/reception buffer is shown below.
With this program, it is assumed that the CC-Link parameters are set as follows.
Parameter setting item Setting value
No. of modules 1 module
Module head input/output No. 0
Module type Master station
Total No. of connected modules 1
Remote input (RX) X100
Batch refresh device
Remote output (RY) Y100
Station type Intelligent device station
No. of occupied stations One station occupied
Transmission buffer size 512
Reception buffer size 512
Station information
Automatic update buffer size 0
<GPPW parameter setting screen>
When the programmable controller series is
QCPU (Q mode)
When the programmable controller series is
QnACPU
<GPPW station information setting screen>