Filter
Top Products
9 - 11
MELSEC-
A
9 PROGRAM EXAMPLES
9.2.3 When using dedicated commands with QCPU (Q mode) / QnACPU
An example of the program for using the dedicated commands with the QCPU (Q
mode) / QnACPU when using the buffer memory automatic update function is shown
below.
With this program, it is assumed that the CC-Link parameters are set as follows.
Parameter setting item Setting value
No. of modules 1 module
Module head input/output No. 0
Module type Master station
Total No. of connected modules 1
Remote input (RX) X100
Batch refresh device
Remote output (RY) Y100
Station type Intelligent device station
No. of occupied stations One station occupied
Transmission buffer size 0
Reception buffer size 0
Station information
Automatic update buffer size 1536
<GPPW parameter setting screen>
When the programmable controller series is
QCPU (Q mode)
When the programmable controller series is
QnACPU
<GPPW station information setting screen>