Mitsubishi Electronics HC9000DW Home Theater Screen User Manual


 
EN-19
13. Press the POWER button on the projector or the STANDBY button on the remote control.
• A conrmation message is displayed.
• To cancel the procedure, leave the projector for a while or press the MENU button.
14. Press the POWER button on the projector or the STANDBY button on the remote control again.
• Thelampgoesoutandtheprojectorgoesintoastandbymode.Inthisstandbymode,thePOWERindicatorsteadyred
and the STATUS indicator go out.
15. Wait about 1 minute.
• During this period of 1 minute in the standby mode, the intake fan and exhaust fan rotate to cool the lamp.
• The lamp can’t be lit again for 1 minute after turning o the projector for safety purpose. If you want to turn on the
projector again, wait until the indicator goes out, and then press the POWER button.
• The air outlet fans rotate faster as the temperature around the projector rises.
• Do not turn o the main power switch or unplug the power cord while the STATUS indicator is blinking. Turning
o the main power switch or unplugging the power cord immediately after use may cause a breakdown.
• Though the fan makes loud sound during cooling, such symptom is not a malfunction.
16. Turn o the main power switch.
• The POWER indicator will go out.
• If the main power switch should be turned o or the power cord should be unplugged accidentally while either
the air inlet fan or the air outlet fans are operating or the lamp is on, allow the projector to cool down for 10
minutes with the power o. To light the lamp again, press the POWER button. If the lamp doesn’t light up
immediately, repeat pressing the POWER button 2 or 3 times. If it should still fail to light up, replace the lamp.
• Cover the lens with the lens cap to protect it from dust.
• For safety’s sake, unplug the power cord from the outlet.
Viewing video images (continued)
10. Adjust with the p or q button to get an approximate size while the Zoom menu is displayed.
11. Press the LENS SHIFT button. The LENS SHIFT menu appears at the center of the screen.
12. Press the p or q button to adjust the vertical position and t or u button to adjust the horizontal position of the
displayed image.
• When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See page 10.)
Repeat steps 4 to 5 and 9 to 12, if necessary.
To stop projecting:
POWER indicator
STATUS indicator
STANDBY button
POWER button
(ON/STANDBY)