Filter
Top Products
EN-25
Viewing 3D images
You can enjoy the 3D fun when you watch 3D movies with 3D Glasses. The 3D Glasses and 3D Emitter shall be purchased
individually; to view 3D images, the special 3D Glasses (EY-3DGS-1U) and 3D Emitter (EY-3D-EMT1) must be purchased.
Before use, it is necessary to read the user manual of the 3D Glasses and 3D Emitter.
• About 3D Glasses (EY-3DGS-1U)
With the 3D Glasses and 3D Emitter, you can enjoy 3D images when you watch the 3D supporting programs on the
projectors supporting 3D images.
You can wear the 3D Glasses over vision corrective glasses.
Battery case
A coin shaped lithium battery
(CR2032) is preinstalled.
When using for the first time,
remove the insulating sheet.
Infra-red receiver
Receives infra-red signals from the 3D
Emitter.
The liquid crystal shutter open/close
timing is controlled by receiving
infra-red signals from the 3D Emitter,
which provide the 3D expression of the
images.
Lens
(liquid crystal
shutter)
On/Standby button and indicator
When turning on the power:
Press the On/Standby button for about 1 second.
The indicator lights for about 2 seconds, then it turns off.
When turning off the power:
When you press the On/Standby button for about 1 second, the indicator will
blink 3 times and the power turns off.
* When the infra-red signal from the 3D Emitter is interrupted, the power turns
off automatically after about 5 minutes.
* If the battery is running low, the indicator blinks 5 times when you turn on the
power.
If necessary, attach
the nose pad.
(inside the 3D
Glasses)
• Preparations
1
Remove the insulating sheet.
Pull the sheet slowly to the
direction of the arrow in the below
gure.
2
Remove the protective sheets.
Remove the protective sheets on
the infra-red reception area and lens
(4 parts) by pulling up each tab as
shown below.
3
If necessary, attach the supplied
nose pad.
When you wear the 3D Glasses over
vision corrective glasses, removing the
nose pad is recommended.