Filter
Top Products
C2630M-B (4/08) 153
Setting Up a Static IP Address
The DX8100 allows you to set up a static IP address. This information can be obtained from your network administrator.
Access the Network page to set up the static IP address. For information on accessing the Network page, refer to Setting Up DX8100 Network
Access on page 151.
To set up a static IP address:
1. In the Network page, verify that the Obtain An IP Address Automatically (DHCP) check box is not selected.
2. In the IP Address box, enter a unique IP address (for example, 10.10.0.170). The last three digits must be different for each recorder (for
example, 171, 172, 173, and so forth).
3. In the Subnet Mask box, enter the subnet mask (for example, 255.0.0.0 is the default).
4. In the Default Gateway box, enter the gateway address (the IP address of the default router on your immediate network segment).
5. Click Apply.
SETTING UP TCP/IP AND BANDWIDTH THROTTLE
The DX8100 uses the TCP/IP networking protocol to communicate over LAN and WAN networks. TCP/IP uses logical network ports to organize
data transmissions and to ensure that data packets are delivered to the proper application. For example, e-mail is traditionally delivered through
TCP/IP port 25 and Web pages through port 80.
The following table describes the ports assigned to direct video and control information into and out of the DX8100. You should keep port
numbers set at their default values unless there is a known conflict with your existing network infrastructure. Consult your network administrator
before changing any port information on the DX8100.
Access the Network page to set up the TCP/IP DHCP and bandwidth throttle options. For information on accessing the Network page, refer to
Setting Up DX8100 Network Access on page 151. Consult your network administrator before assigning or changing port numbers. Make sure that
the ports are not blocked internally but are protected from external threats by a firewall. Client and server ports must be identical.
To configure the base port and software upgrade port:
1. If necessary, in the DX8100 Base Port box, enter a new base port number (9002 is the default).
2. If necessary, in the Software Upgrade Port box, enter a new software upgrade port (9003 is the default).
3. If necessary, in the Information Port box, enter a new information port (9005 is the default).
4. To set the network bandwidth throttle to limit the amount of network resources allocated to client connections, drag the network bandwidth
throttle slider to the desired value. (Client bandwidth can be adjusted from a minimum of 64 Kbps to a maximum of 10 Mbps in increments
of 64 Kbps.)
5. Click Apply.
Table AO. TCP/IP Ports Used by the DX8100
Port Number User Changeable Description
9002 Yes Base port for transmission of video, audio, and interface data
9003 Yes Software upgrades
9004 Yes Emergency agent notifications
9005 No Information port
13900 No Ping port