Filter
Top Products
214 C2630M-B (4/08)
c. Select a screen division.
d. Drag cameras from the Site tree onto each view panel, until all panels have been assigned a camera.
e. From the Min and Sec drop-down boxes, select the amount of time the sequence instance will remain on the monitor.
f. Click Modify.
g. Click Save.
The Save dialog box open.
4. Select an existing profile or enter a new profile name under which to save the sequence list.
5. Click OK.
6. Click Apply.
7. Click Apply in the External Monitor page.
Figure 178. Modify a Mapping Sequence
Deleting a Sequence Instance from the List
To delete a sequence instance from the list:
1. On the DX8100 toolbar, click . The Setup dialog box opens to the Camera page.
2. Click . The External Output page is displayed.
3. In the Manual Camera Mapping Mode section, do the following:
a. In the Sequence Table, click the check box next to the sequence instance you want to delete.
b. Click Delete.
c. Click Save.
The Save profile dialog box opens.
4. Select an existing profile or enter a new profile name under which to save the sequence list.
5. Click OK.
6. Click Apply.
3e
3e
3a
3a
ᕦ
3
d
3c
3f
3f 3
g
3
b