Filter
Top Products
176 C2630M-B (4/08)
Creating an ATM/POS Exception
To create an ATM/POS exception:
1. In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2. In the Communication Port drop-down box, select a port (Port 1 to Port 4). The device mode option is not available for COM1.
3. In the selected device drop-down box, select an ATM/POS device.
4. In the Communication Port Configuration section, click Configure. The Device Configuration page is displayed.
5. Click the Advanced tab. For information about the Advanced page, refer to Setting Up ATM/POS Exceptions on page 174.
6. In the ATM/POS Name drop-down box, select an ATM/POS device.
Figure 153. Advanced Page
ᕤ
ᕥ
ᕦ