Filter
Top Products
126
Recording edited pictures from tape as a moving picture
– Digital program editing (on “Memory Stick”)
Performing the program (Dubbing the “Memory Stick”)
The POWER switch should be set to .
Operate by touching the panel.
(1) Press FN to display PAGE1.
(2) Press MENU to display the menu.
(3) Select VIDEO EDIT in
, then press EXEC (p. 182).
(4) Select MEMORY, then press EXEC.
(5) Press START.
(6) Press EXEC.
Your camcorder searches for the beginning of the first program, then starts
dubbing.
The program mark flashes.
The SEARCH indicator appears during searching, the EDITING indicator
appears during writing of data on your camcorder, and the REC indicator
appears during dubbing on the screen.
The program mark changes to light blue after dubbing is complete.
When the dubbing ends, your camcorder automatically stops.
To stop dubbing
Press CANCEL.
The program you made is recorded on the “Memory Stick” up to the place where you
pressed CANCEL.
To end Digital program editing
Your camcorder stops when the dubbing ends. Then the display returns to VIDEO
EDIT in the menu settings.
Press END to end Digital program editing.
Note
In the following instances, recording may stop in middle, or distorted images may be
recorded:
– If the tape has a blank portion
– If recording from a tape in a poor condition, such as one that has been reused often for
recording
The NOT READY indicator appears on the screen when:
– The program to operate Digital program editing has not been made.
– The “Memory Stick” is not inserted.
– The write-protect tab on the “Memory Stick” is set to LOCK.
When the available recording time of the “Memory Stick” is not enough
The LOW MEMORY indicator appears on the screen. However, you can record pictures
up to the time indicated.
When the program has not been set
You cannot press START.