Filter
Top Products
134
Error Messages and Warning Messages
Appendix
Error Messages and Warning Messages
Error Messages
When the unit ceases to operate correctly due to
malfunction or an internal system error, the alarm will
sound and an error message will be displayed on the
display.
Only one message will be displayed even when multiple
errors occur, but the error log menu keeps a history of the
errors.
For more information about error messages, refer to the
Maintenance Manual.
After the error occurs, eliminate the cause of the error and
turn the unit back on. If the error message appears again
when the unit is turned on, contact your Sony
representative.
For more information about eliminating errors, refer to
the Maintenance Manual (Volume 1).
Protection mode
To protect the tape and the mechanical parts of the VTR,
the servo control system automatically stops tape transport
and the drum motor and enters protection mode when an
error occurs.
Cassettes may not be inserted or ejected during protection
mode.
When a cassette is stuck in the unit because of protection
mode, make sure to disconnect the power before removing
the cassette manually.
For information about removing cassettes manually, refer
to the Maintenance Manual (Volume 1).
.
Note
Item number Display Meaning
01 REEL SLACK THREAD ERROR Tape slack was detected during threading or unthreading.
02 REEL SLACK SHTL ERROR Tape slack or a broken tape was detected during search, fast
forward, or rewind.
03 REEL SLACK VAR ERROR Tape slack, a broken tape, or an S-side reel or T-side reel lock was
detected during recording or playback.
04 REEL SPEED ERROR Tape transport speed error was detected during forward winding or
rewinding.
05 REEL FG ERROR When a cassette was inserted, a fault in the S-side reel or T-side
reel operation was detected.
06 OVER TENSION During recording or playback, excess tension was detected.
07 CAPSTAN ERROR A capstan motor operation fault was detected.
08 DRUM ERROR A drum motor operation fault was detected.
09 THREAD TIME OVER A fault was detected in a threading or unthreading operation.
0A FULL TOP ERROR When threading, a failure of the tape beginning processing to
terminate was detected.
10 HUMID DETECT Condensation was detected.
11 TOP END BOTH DETECT The tape beginning and tape end were detected at the same time.
Error message
00H 02M 39S 18F
AIN --:--:--:-- AOUT --:--:00:00
IN --:--:--:-- OUT --:--:00:00
PB/EE
LTC
TCR
INTRP DF 2FO F2
PLAY LOCK
RECINH
off
ASSEM-
BLE
off
INS
TC
off
INS
VIDEO
off
INS
A-CH2
off
INS
A-CH3
off
INS
A-CH4
off
INS
CUE
off
INS
A-CH1
off
AIN --:--:--:-- AOUT --:--:00:00
IN --:--:--:-- OUT --:--:00:00
ERROR - 88
SYS1 - SYS2
INTERFACE ERROR
Total 1 message