72
4-4 CUE Menu
Chapter 4 Menu Settings
Prerolling to a cue point
1
Press the ALT/[F8] (PAGE MODE) buttons or the
ALT/[F9] (EXTEND MODE) buttons.
2
If you selected PAGE mode, press the [F1] (PREV
PAGE) button or [F2] (NEXT PAGE) button to select
a desired page (or use the numeric buttons to enter the
page number in the data entry window, then press the
[F8] (PAGE SET) button).
3
Press the cursor R or r button to move the cursor (B) to
the cue number.
To select the cue number directly by the numeric
buttons
Enter the cue number in the data entry window with
the numeric buttons, then press the [F9] (CUENUM
SET) button.
4
Press the PREROLL button.
4-4-5 Changing a Cue Point Into an
Edit Point
Follow the procedures below to change a selected cue
point into an edit point.
To change an edit point into an IN point
Press the SET button while holding down the IN button.
To change an edit point into an OUT point
Press the SET button while holding down the OUT button.
To change an edit point into an AUDIO IN point
Press the SET button while holding down the AUDIO IN
button.
To change an edit point into an AUDIO OUT point
Press the SET button while holding down the AUDIO
OUT button.
4-4-6 Backspace Editing
You can perform backspace editing with the CUE menu. In
backspace editing, assemble editing is performed from the
recording end point. Thus, before starting backspace
editing for the first time, you must record for at least one
minute or so on the tape before you can do backspace
editing. After recording, the present end of the recorded
portion becomes the recording end point. When you press
the AUTO button and then press the REC/EDIT button, the
VTR automatically prerolls a few seconds before the
recording end point and starts assemble editing. If no data
for the recording end point exist, backspace editing is not
performed.
The recording end point will be cleared when you eject the
tape.
Cue point data is cleared when a cassette is inserted.
However, cue point data recalled from a memory stick
before a cassette is inserted is not cleared when a cassette
is inserted.
4-4-7 TELE FILE Menu
The TELE FILE menu screen is different in HDCAM-SR
and HDCAM formats.
In HDCAM-SR format: The cassette has a memory label
attached as standard, and this screen allows
operations to read out, enter, or change the cassette ID
identification, recording format, recording
information, management information, and so on. In
the HDCAM-SR format, each recording
automatically adds recording information. However,
if the recording time is less than 2 seconds, or if when
recording ends the measurement on the spool was not
complete, then no recording information is added. In
the case of an HDCAM-SR cassette, a cassette
without a memory label is ejected.
1 34
2
Note
AUDIO IN button
AUDIO OUT button
IN button
SET button
OUT button