137
Error Messages and Warning Messages
Appendix
Error Log Menu
The time and time codes of errors and warnings occurring
during operation can be displayed in a list form in the
display. (Maximum listing is 99 items.)
To open the error log menu
Press the SFT button (see page 19) and the DIAG button
(see page 18), then press the [F2] (ERR LOG) button.
2D INVALID SDI DATA SDI input signal data is invalid.
34 NO CASSETTE COMPARTMENT
MODE
The cassette compartment does not operate because the VTR is in
“no cassette compartment” mode.
3B NO LTC REPRODUCED LTC signal not detected on the tape.
52 NO SUPPORTED PB FORMAT The recording format cannot be played back by this unit.
53 SYSTEM MISMATCH The tape cannot be played with the current system settings.
55 VIDEO PLL UNLOCKED Video lock generator PLL not locked to the video reference signal.
59 INPUT AUDIO DATA MISMATCH
32.000K
The input audio frequency is wrong.
5A INPUT AUDIO DATA MISMATCH
47.056K
The input audio frequency is wrong.
61 TELEFILE MEMORY IS FULL The remaining capacity of the Tele-File is low, and therefore the
next recording will overwrite old data.
62 NO AREA FOR TELEFILE DATA
ADDITION
There is no space at all in the Tele-File.
63 INVALID FORMAT TELEFILE Parts of the Tele-File format are wrong.
64 TELEFILE DATA WRITE FAIL A write to Tele-File error occurred.
65 NO TELEFILE LABEL The Tele-File could not be recognized, and therefore the cassette is
ejected (HDCAM-SR only).
66 TELEFILE DATA WRITE IS
INHIBITED
Recording or editing was started with the Tele-File in overall write
inhibit mode.
67 TELEFILE DATA READ FAIL A Tele-File read error occurred.
71 INVALID FORMAT CONVERSION The settings do not allow format conversion.
72 REC/EDIT DISABLE CASSETTE
FORMAT
The inserted cassette cannot be recorded or edited because of
system settings (recording format, system line, etc). This display
applies only to HDCAM/HDCAM-SR cassettes (SRW-5500 only).
73 NO REFERENCE INFORMATION Cannot lock because there is no 30 frames/second reference
information in 720/59.94p HD SDI input signals.
74 ASYNCHRONOUS VIDEO INPUT When external sync is selected, the external sync signal and the
HD SDI INPUT signal are more than ±5H out of phase.
77 AUTO CUEUP ABORT Auto cue-up was aborted because the target cue-up time code is 1
second or more away from the current time code.
Item number Display Meaning
95.00:00:00:00 (W) 1B
NO A5/A6 INPUT
96.00:00:00:00 (W) 1C
NO A7/A8 INPUT
97.00:00:00:00 (W) 1D
NO A9/A10 INPUT
95.00:00:00:00 (W) 1E
NO A11/A12 INPUT
TOTAL 99
PAGE
END
PAGE
TOP
ALL
CLEAR
TC
WARNI-
NG
on
ERROR
on
TIME
FULL
MSG
CONDI-
TION
on
EXIT
ERROR LOG '03/06/02 10:27:28