Filter
Top Products
148
Menu List
Appendix
Items Relating to Remote Interface (Nos. 201 to ...)
129 STOP CODE
FUNCTION
Stop code detection mode and adjustment of stop position
when a stop code is detected.
Sub items
DETECT BEEP on
[off]
on: When a stop code is detected, sound a beeper.
off: When a stop code is detected, do not sound a beeper.
DETECT STOP on
[off]
on: When a stop code is detected, stop the tape. (“D-
STOP” appears in the information display.)
off: When a stop code is detected, do not stop the tape.
STOP ADJUST 150 fr
[0 fr]
When a stop code is detected, adjust the tape stop position
from the normal stop position in the direction of the SOM
point (program start point), in the range 0 to 150 frames.
REC ADJUST 5sec
4sec
[3sec]
2sec
1sec
Specifies how many seconds before the SOM point to start
recording a stop code.
130 S-LCD DIMMER 16 to [11] to 0 Adjusts the information display luminance.
131 CHANGED MENU
HIGHLIGHT
Changes the display color of items whose setting has been
changed.
Sub items
ITEM SETTING [off]
on
off: Changed menu setting values do not change display
color.
on: Changed menu setting values are displayed in yellow.
DEFAULT
SETTING
[off]
on
off: Menu numbers with changed DEFAULT values do not
change display color.
on: Menu numbers with changed DEFAULT values are
displayed in yellow.
132 KNOB MODE [set default]
move window
Selects the behavior of the unit when the MULTI CONTROL
knob is pressed during VTR SETUP menu operations.
set default: When a setting value is being selected, selects
the default value.
move window: Move between the item window and the
window for changing values.
Item number Item Setting Function
201 REMOTE 9-PIN [off]
on
When this is set to “on”, this unit is controlled from the
device connected to the REMOTE 1-IN(9P) or REMOTE 1-
I/O(9P) connectors.
Note
When this unit is controlled by a device connected to the
REMOTE 1-IN(9P) or REMOTE 2 PARALLEL I/O(50P)
connector, the editing control buttons and all of the tape
transport buttons except STOP and EJECT are disabled. It
is also possible to make a setting so that all of the buttons
are disabled.
For details, see item 008.
202 REMOTE 50-PIN [off]
on
When this is set to “on”, this unit is controlled from the
device connected to the REMOTE 2 PARALLEL I/O(50P)
connector.
Item number Item Setting Function