Filter
Top Products
Installing Avaya Communication Manager
Installing and Configuring the Avaya S8500 Media Server February 2007
37
Installing Avaya Communication Manager
Use a Telnet session to access the information on the CD-ROM.
1. On your Services laptop computer, click Start > Run to open the Run dialog box.
2. Type telnet 192.11.13.6 and press Enter to view the first screen.
Note:
Note: To navigate on these screens, use the arrow keys to move to an option, and then
press the spacebar to select the option. Press Enter to submit the information on
the screen.
3. Select Install, ensure that <OK> is highlighted, and press Enter.
4. On the Select Release Version screen, ensure that the Build line and <OK> are
highlighted. Press Enter to partition the hard disk drive and reformat the partitions.
Once the drive is properly configured, the program starts the installation process and
reports the progress.
These processes can take up to 20 minutes to complete.
5. You must remove the CD-ROM from the drive at this time. When the media server is ready
to reboot, the drawer of the CD-ROM drive opens.
The reboot can take up to 3 minutes. The Telnet session drops automatically when the
reboot starts.
6. Perform one of the following actions:
● If you are installing the S8500 Media Server as a call controller, continue with the next
section of this document.
● If your are installing the S8500 as an LSP, continue with Chapter 7: Install an S8500
Media Server as an LSP on page 63.