Filter
Top Products
Chapter 5: IP interface translations
52 Installing and Configuring the Avaya S8500 Media Server February 2007
Adding the IPSI to the system
Use the IP Server Interface Administration - Port Network SAT screen to add an IPSI. The
information on this screen differs, depending on whether the IP addresses of the IPSI are static
or assigned automatically through DHCP.
1. Type add ipserver-interface PNnumber and press Enter.
2. In the Host field, enter the IP address for the IPSI that is listed in the Location field.
3. Set the IP Control field to y.
4. Verify that all the other fields are populated and submit the form to save the changes.
5. Repeat this procedure for each port network.
Setting the alarm activation level
1. At the SAT, type change system-parameters maintenance and press Enter.
2. In the CPE Alarm Activation Level field, enter none, warning, minor, or major,
according to the customer request.
3. Submit the screen to save the changes.
4. Repeat this procedure for each IPSI.
Saving translations
To save the translations to the hard disk drive, at the SAT, type save translation and press
Enter.
add ipserver-interface 8
IP SERVER INTERFACE (IPSI) ADMINISTRATION - PORT NETWORK 8
IP Control? y Socket Encryption? n
Ignore Connectivity in Server Arbitration? n Enable QoS? n
Primary IPSI QoS Parameters
------------ --------------
Location: 1A01 Call Control 802.1p: 6
Host: 172.22.22.174 Call Control DiffServ: 46
DHCP ID: ipsi-A01a