Filter
Top Products
Chapter 7: Install an S8500 Media Server as an LSP
68 Installing and Configuring the Avaya S8500 Media Server February 2007
Verifying that the primary controller identifies the
new LSP
1. Wait several minutes after you reset the S8500 LSP. On the primary controller, run the SAT
command list survivable-processor to verify that the LSP server registers, and
that translations are updated.
2. If the LSP is registered, the Service State? field shows in-service and the Translations
Updated field shows the time and the date of the update.
Readministering media gateways to point to the LSP
Change the controller list for each G700, G350, or G250 Media Gateway that uses the LSP as
an alternate controller. This change enables the media gateway to seek service from the LSP if
the connection to the primary controller fails.
For how to change the controller list of the media gateway, see one of the following documents:
● Installation and Upgrades for the Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100
● Installation and Upgrades for the Avaya G250 Media Gateways, 03-300434
● Installation and Upgrades for the Avaya G350 Media Gateway, 03-300394
list survivable-processor Page 1 of xx
SURVIVABLE PROCESSORS
Name Type ID IP Address Service Translations
State? Updated
LSPNYC LSP 04 128.256.173.101 in-service/idle 03:21 02/19/03
LSPCHI LSP 05 128.256.113.213 out-of-service 04:32 02/20/03