Filter
Top Products
2. Installation requirements
2.2 Electrical requirements for the OLite rental display
Power requirements
One OLite tile requires 200-240 VAC, 50-60 Hz, 4.22 amps at 230 VAC. Note that one OLite tile correspond with a display surface
of 0.6 m². Each OLite tile has a control box with a power loop through connector. However, MAXIMUM 2 OLite control boxes may
be connected in parallel. So, one power source cable has to be provided per 2 OLite tiles. Every power source cable should be
protected by a circuit breaker or fuses rated 16 A / 250 VAC (15 A / 250 VAC in the USA and Canada).
Barco provides a range of power boxes, which meet the requirements of your OLite display. Contact Barco
for more information about power boxes and power requirements for your OLite display.
Power system:
It is recommended to use a TN-S power distribution system (a power distribution system with a separate neutral and groun
ding
conductor) in order to avoid large ground current loops due to voltage differences in the neutral conductor. The total electrical
installation should be protected by an appropriately rated disconnect switch, circuit breakers and Ground Fault Current Interrupters.
The installation shall be done according to the local electrical installation codes. In Euro
pe special attention should be given to EN
60364, the standard for electrical installation of buildings. In Germany VDE 0100 should be adhered to.
Disconnect device:
When the appliance inlets of the individual tiles are not accessible, the socket outlets supplying the rack shall be installed near the
equipment and be easily accessible, or a readily accessible general disconnect device sha
ll be incorporated in the fixed wiring.
This equipment MUST be earthed:
In order to protect against risk of electric shock, the installation should be properly grounded. Defeating the purpose of thegrounding
type plug will expose you to the risk of electric shock.
R5976832 OLITE RENTAL DISPLAY 29/05/2007
11