Filter
Top Products
7. Basic set up procedures
7.5 Attach an OLite truss beam upon an OLite rental tile
The following procedure is written and illustrated for a single OLite truss beam. The same procedure can be
applied for a dual OLite truss beam. Four lock handles instead of two have to be manipulated.
How to attach an OLite truss beam upon an OLite rental tile ?
1. Ensure that the locking mechanisms of the OLite truss beam are unlocked. So, handles in vertical position and pulled out.
1
2
Image 7-9
Place the truss beam locking mechanisms in the unlocked position.
2. Place the OLite truss beam upon the OLite rental tile. Ensure that the truss beam and tile are equally oriented.
3. Lock the truss beam and the tile together by pushing the handles o
f the truss beam inside and then turning the handles in their
horizontal position. The left handle in clockwise direction and the right handle counterclockwise, seen from the rear of the truss
beam.
1
2
Image 7-10
Place the handles of the truss beam in t
he locked position.
44 R5976832 OLITE RENTAL DISPLAY 29/05/2007