Filter
Top Products
8. Cabling of an OLite rental display
8.1 Power cabling of an OLite rental display
Power boxes
Barco provides several types of power boxes. Depending on the size of the OLite rental display you can choose to use the mono
phase power box, custom made power box or rental power box. The type of power box, does not influence the power cabling of the
OLite rental display. See installation manual of the concerned power box for installation instructions.
WARNING: Risk of electric shock / Risk of fire: To protect against risk of fire caused by overloading of power
cables, MAXIMUM 2 may be connected in parallel. Each power source cable supplying maximum 2 should be
protected by a circuit breaker or fuses rated 16 A / 250 VAC (15 A / 250 VAC in the USA and Canada). Note that
one OLite tile requires 200-240 VAC, 50-60 Hz, 4.22 amps at 230 VAC.
Necessary parts
• Power box(es) with matching cables.
• Power linking cables.
• Dummy power plugs
How to realize the power cabling of an OLite rental display ?
1. Install the power box nearby the OLite rental display. Ensure the power box provides as much power circuits as required to
energize the display ina safe manner. If necessary, install several power boxes. See manualof the u
sed power box forinstallation
instructions.
2. Connect a power source cable coming from the power box with the lower tile in a column of two high.
Note: Depending on the type of used power box, a multi power cable in combination with a spider connector is inserted between
the power box and the power source cable leading to the OLite tile. See manual of the used power box to realize the
cabling between pow er box and OLite disp lay.
3. Place a power linking cable between the tile, receiving power directly from the power box via a power source cable, and the tile
above.
4. Place a dummy power plug on the power output socket of the upper tile in the power branch.
5. Make sure that all plug holder clamps are locked firmly.
6. Repeat from step 2 until all OLite rental tiles are provided with power.
Example of power cabling
The example below shows the power cabling of a two by two OLite rental display. The rental power box (A) is connected via a multi
power cable (B) with a spider connector (C). Each spider output cable lea
ds to a column of two OLite tiles. The power connection
in this column is realized with a power linking cable (D). Note that the unused power output socket is sealed with a dummy power
plug (E).
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
POWER
DATA
OUT
IN
A
B
C
D
E
Image 8-2
60 R5976832 OLITE RENTAL DISPLAY 29/05/2007