Filter
Top Products
Remote Controls
73
Improving Receiver Control
Checking the Remote Control Address
1 Press and hold the SAT mode button until all of the mode buttons light up, then release it.
2 Press POUND (#) twice. The SAT mode button will flash the same number of times as the
address number (for example, three flashes means address 3).
Confirming Remote Control Operation
1 Make sure the remote has fresh batteries and is in SAT mode.
2 Press SYSTEM INFO on the receiver front panel to display the System Information screen
on the nearby TV.
3 Press RECORD on the remote control:
• Remote Control 1—The Primary Remote Address in the System Information screen
changes to match the address preset in your remote control. Typically, the remote
control for the nearby TV is IR only, unless you have received an IR/UHF Pro remote
replacement.
• Remote Control 2—The Secondary Remote Address in the System Information
screen changes to match the address preset in your TV2 remote control. Odd-
numbered remote addresses will automatically use UHF Pro Band A, while even-
numbered addresses will use UHF Pro Band B. If you have two UHF Pro remote
controls in your house, ensure one uses an odd-numbered remote address and the
other an even-numbered address. If you have more than two DISH Network remote
controls, consult the SYSTEM INFO screen on each receiver and ensure that all the
IR/UHF Pro remotes use different addresses.
4 Select Done to close the System Information screen.
5 Press POWER on the remote control to turn the receiver on or off.