Filter
Top Products
90
Using Shared View
Chapter 11
USING SHARED VIEW
Shared View is a feature of Single Mode that lets you activate the TV2 audio and video
outputs to display the same programming as the TV1 outputs. While using this feature,
both Remote Control 1 and Remote Control 2 for your satellite receiver can control what is
displayed on all TVs connected to the system. This feature is available only in Single
Mode.
Note: Make sure you are using Remote Control 1 and TV1 because you cannot enable or
disable this feature using Remote Control 2.
Note: If you do not want to display programming on any other TV besides TV1 and you do
not want Remote Control 2 to control the receiver, select Disable View. After you select
Done, TV2 will show a screen that says Shared View is currently disabled.
MODULATOR SETUP
If you have TV1 and TV2 connected to the receiver with coaxial cables (see page 107),
you can decide which channel you’d like to use to view your DISH Network programming.
If you have the system locked, you’ll have to enter the password to enable TV1’s output on
this screen. Make sure your TV can tune to the channel you pick before you change the
setting on this screen.