Filter
Top Products
Remote Controls
85
Controlling Other Components
To set the remote back to adjust the TV volume (steps 1-5 set up the remote and steps
6-7 make sure the remote is set up correctly):
Programming to Control a Second Satellite Receiver
If you have another DISH Network satellite receiver installed, you can use this remote in
AUX mode to control it along with your new receiver. When you program the remote to
control this other receiver, the remote will send out IR signals to the receiver. You can
program the remote to control any other DISH Network satellite receiver, except for the
following:
• TV2 on a DISH 322, ViP222, ViP222k, ViP622 DVR, ViP722 DVR,ViP722k DVR,
DISH Player-DVR 522, 625, and 942 receivers
• DishPlayer 7100/7200 receiver.
1 Turn on the other receiver and display the System Info screen.
Write down the receiver’s address:
2 Using the new remote control, press and hold AUX until all the other mode buttons light
up, and then release the button. AUX flashes.
3 Press the 3 button.
4 Use the NUMBER PAD to enter the address you wrote in step 1.
5 Press POUND (#). AUX blinks three times.
6 Press RECORD and ensure the remote’s address matches the other receiver’s address.