Filter
Top Products
C H A P T E R 6Intel® NetStructure™ 7190 Multi-Site Traffic Director User Guide
100
config dns agents
<agentname>
flash-src
<ipaddress>
NOTE: At least one of the
(up to 5) unique flash-
source addresses must be
the IP address of the 7190
itself.
Configures the IP address of the peer flash sources. These include
the IP addresses of this 7190 itself and additional 7190s if they
exist. Up to five unique flash-source addresses can be configured
among the sixteen possible agents.
flash-port <port#>
Sets or changes the UDP port number through which flash peers
communicate to each other. The default port number is 2000.
flash-backup-src
<ipaddress>
Configures a backup source address to which queries are routed,
in the event of this 7190 not being functional. The backup source
address is the IP address of another 7190 or a load balancer with a
flash-agent configured.
flash-backup-port
<port#>
Configures the port number with which the backup flash source
communicates with its known peers. The default port number is
2000.
interval
Configures the interval at which metrics are gathered from the
specified agent. The default is 30 seconds.
Syntax:
config dns agents <agentname> interval <seconds>
where:
agentname is the name of the agent whose metric-gathering
interval you wish to set.
seconds is an integer between 1 and 300 seconds.
config dns agents
<agentname>
timeout
Establishes the time that elapses during which the NCA waits for
metrics from the specified agent before assuming the agent to be
dead. The default value is 15 seconds.
Syntax:
config dns agents <agentname> timeout <seconds>
where:
agentname is the name of the agent whose metrics gathering
timeout interval you wish to set.
seconds is an integer between 1 and 300 seconds.
Command Description
Config DNS Agents Commands