Filter
Top Products
C H A P T E R 6Intel® NetStructure™ 7190 Multi-Site Traffic Director User Guide
84
telnet-sessions
NOTE: If you set the
number of sessions to 0,
you are disabling all future
Telnet sessions to the 7190.
To reset Telnet, you must
access the device through
the serial port and login,
then change the Telnet
session count from 0, to a
number from 1 to 8
Sets the allowable number of concurrent inbound remote CLI
login sessions.
Syntax:
config CLI telnet-sessions <nsessions>
where:
nsessions is the number of allowed sessions (0 to 8). The
default number of sessions is 0. .
timeout
NOTE: Too small of a
timeout value renders the
CLI useless.
Sets or changes the idle timeout period before automatic logout
for CLI sessions. The timeout value can be set to 0, which
specifies no timeout
. To set a value, use the range 30 to 65535
seconds.
Syntax:
config CLI timeout <seconds>
where:
seconds is the timeout period in seconds (0, or a range of 30 to
65535). The default is 900 seconds (15 minutes).
Command Description
Config CLI Commands