Filter
Top Products
C H A P T E R 5 Boot Monitor Command Reference
55
netmask
Use this command to specify the netmask.
Example:
monitor>netmask
Enter Netmask [255.255.254.0] --->255.255.254.0
nic
Use this command to configure network interface card (NIC)
parameters. Assurance of compatibility with some older switches, hubs,
or routers, may require that you directly specify the Ethernet speed and
duplex mode of the network interface card for the 7190. The nic
command, available at the serial console, allows you to specify these
characteristics.
Example:
monitor>nic
Auto config NIC card? [y] --->n
1 - 100BaseTx
2 - 10BaseTx
Select Media Type (1 or 2): [1] --->1
Use Full Duplex? [y] --->y
Done Ether config: 100basetx,full_duplex
route
Use this command to specify the default route (gateway).
Example:
monitor>route
Enter default route [10.1.1.1] --->
save
Use this command to save the current configuration. Changes made
during the current Boot Monitor session are lost unless you use the
save command.
Command Description
Boot Monitor Command Reference