Filter
Top Products
C H A P T E R 8 Rebooting with the New Image and Verifying Installation
147
Rebooting with the New Image and
Verifying Installation
NOTE: If any errors
occurred during
installation, show sys
software may display
the image as installed,
however it is not safe to
use. Use config sys
software delete to
delete the image and
repeat the installation
before continuing. If the
problem persists, contact
Intel Technical Support.
When the image has been downloaded and installed, it can be verified
by typing show sys software info. For example, after
downloading and installing an update, show sys software
info may display the following:
This indicates that the image at index 1 has been installed and is ready
for service, and the image at index 2 is running. To activate the new
image, type config sys software boot 1. The 7190 reboots
under the new image. This command can also be used to revert to the
previous version.
Restoring Your Previous Configuration
After the 7190 reboots and comes up under the new image, you can
restore your previous configuration with the restore command.
Index Product Version Patch Build
1 7190 3.0 1.0 D1
2 7190 3.1 0.0 D12 (running)