Filter
Top Products
C H A P T E R 7Intel® NetStructure™ 7190 Multi-Site Traffic Director User Guide
142
The following CLI commands are used to display and configure
SNMP community strings.
config sys snmp community info
config sys snmp community create <string> ip <ip
address> rights [ro|rw]
config sys snmp community delete <string> ip <ip
address>
For example:
config sys snmp community create test ip
209.218.240.5 rights ro
This command creates the community string test with read-only
privilege. SNMP read-only requests using community string test are
accepted only from IP address 209.218.240.1.
By default the following community strings are defined:
public ro any
private rw any
Configuring
Trap
Parameters
Use the following CLI commands to display and configure SNMP
trap parameters:
config sys snmp trap info
config sys snmp trap port <port>
config sys snmp trap create <ip address>
community <community>
config sys snmp trap delete <ip address>
community <community>
By default, the UDP port used for sending traps is 162. The trap port
can be changed to a number between 5020 and 65535, or left at 162.
The 7190 SNMP can send trap notifications to up to ten configured
trap receivers. Each IP address configured as a trap receiver is
associated with a community string included in traps sent to that IP
address. For example:
config sys snmp trap create 209.218.240.5
community NOC1