Filter
Top Products
Intel
®
NetStructure
TM
ZT 7102 Chassis Management Module
Hardware Specifications
24 Technical Product Specification
2.8.1 J1 Backplane Connector
J1 is a 110-contact, 2 mm x 2 mm female CompactPCI form-factor connector (AMP 352152-1).
See Table 5 for pin definitions and Figure 6, “Backplane Connectors - Pin Locations” on page 23
for relative pin placement.
2.8.2 J2 Backplane Connector
J2 is a 55-contact, 2 mm x 2 mm female CompactPCI* form-factor connector (AMP* 352115-1).
See Table 6 for pin definitions and Figure 6 for relative pin placement.
Table 5. J1 Connector Pinout
Pin# A B C D E F
22 PDEG0# PDEG2# GND PDEG4# PDEG6#
GROUND
SHIELD
21 PDEG1# PDEG3# IPMB_PWR PDEG5# PDEG7#
20 PFAIL0# PFAIL2# GND PFAIL4# PFAIL6#
19 PFAIL1# PFAIL3# IPMB_PWR PFAIL5# PFAIL7#
18 PINH0# PINH2# GND PINH4# PINH6#
17 PINH1# PINH3# IPMB_PWR PINH5# PINH7#
16 PS_SCL0 PS_SDA0 GND PRES_I# GA0
15 PS_SCL1 PS_SDA1 RES FANP0# FANP2#
14 FT_SCL FT_SDA GND FANP1# FANP3#
13 CS_SCL CS_SDA RES FANPWM0 FANPWM2
12 CF_SCL0 CF_SDA0 GND FANPWM1 FANPWM3
11 CF_SCL1 CF_SDA1 RES FANTK0 FANTK8
10 RES RES GND FANTK1 FANTK9
9 RES RES RES FANTK2 FANTK10
8 STx SRx SRI FANTK3 FANTK11
7 SCTS SRTS SCD FANTK4 FANTK12
6 SDSR SDTR RES FANTK5 FANTK13
5 RPMAC# RPMIC# RES FANTK6 FANTK14
4 RPCR# RPMAR# RPMIR# FANTK7 FANTK15
3 BP_5V BP_N12V BP_12V BP_3.3V VIO
2 SwTx+ SwTx- GND RpTx+ RpTx-
1 SwRx+ SwRx- GND RpRx+ RpRx-
NOTE: # Designates a low true signal. All signals interface to medium length pins on the backplane.