Filter
Top Products
Intel
®
NetStructure
TM
ZT 7102 Chassis Management Module
Command Line Interface (CLI) Syntax and Arguments
Technical Product Specification 59
thresholdsall
All thresholds of a sensor. This includes lower
non-recoverable, lower critical, lower non-critical, upper
non-critical, upper critical, and upper non-recoverable.
Get N/A
uppercritical
uppernoncritical
lowercritical
lowernoncritical
uppernonrecoverable
lowernonrecoverable
Used to query individual thresholds for a value based
sensor, such as temperature or voltage.
Get N/A
eventaction
Used to trigger a script based on event code of a health
event. Refer to Section 18.0, “CMM Scripting” on page 93
Set
The event code
of the event
Table 24. dataitem (-d) Keywords for System location
Data Item Description
Get/
Set
Valid Set
Values
unhealthylocations
Output:
Critical: CritList
Major: MajList
Minor: MinList
where each list is a list of locations having that level of
health events (space separated).
In the output, PSn refers to PowerSupplyN (i.e., PS1 =
PowerSupply1, PS2 = PowerSupply2, etc.)
Get N/A
Table 25. dataitem (-d) Keywords for BladeN Locations
Data Item Description
Get/
Set
Valid Set Values:
ignorespcirst
Used to add IPMI capable drone mode compatible
blades to the list of recognized drone mode boards. For
further information on drone mode see Section 14.0,
“Drone Mode SBC Support” on page 85.
Set
1 - Add board to
drone mode list
0 - Delete board
from drone mode
list
powerstate
Used to query or control the power state of a board. This
is also used to reset a board.
Both
poweron
poweroff
reset
offline
activate
Table 23. dataitem (-d) Keywords for All Locations (Sheet 2 of 2)
Data Item Description
Get/
Set
Valid Set
Values: