Filter
Top Products
Chapter 5 Power Supply / CPU
5 -21
3) Debug operation conditions
following four operation conditions can be specified.
Operation conditions Description
executed by one
command.
When executed, Stop operation after executing one instruction
executed by break-point
settings.
When executed, Stop operation at designated break-point
executed by the
condition of the device
When executed, Stop operation by condition of designated device’s status
executed by the
specified scan time
When executed, Operates specified scan time.
4) Operation method
(1) Execute the operation after the debug operation conditions have been set in the KGLWIN.
(2) In interrupt programs, each task can be specified to operation enable/disable.
For detailed operation method, refer to the KGLWIN User’s Manual Chapter 9.
5.5.5 Operation Mode Change
1) Operation mode change methods
The following method is used to change the operation mode.
(1) Change by the mode-setting switch of CPU module.(Standard type only)
(2) Change by the KGLWIN connected with the CPU module communications port.
(3) Change by the KGLWIN connected to the remote CPU module through Cnet I/F
(4) Change by the ‘STOP’ instruction, during program execution.
(5) Change by the KGLWIN connected to the remote CPU module through Fnet(Standard type only)
2) Operation mode change by the mode-setting switch of CPU module.(Standard type only)
The following shows the operation mode change by the mode-setting switch of CPU module.
Mode setting switch position Operation mode
RUN Local RUN
STOP Local STOP
STOP → PAU / REM
Remote STOP
PAU / REM → RUN ∗ 1
Local RUN
RUN → PAU / REM * 2
Local PAUSE
PAU / REM → STOP
Local STOP
REMARK
-. If the operation mode changes from RUN mode to local RUN mode by the mode setting switch, the
PLC operates continuously without stopping.