Filter
Top Products
92
(b) Auto refresh
Set auto refresh destination devices.
Project window [Intelligent Function Module] [LD62] [Auto_Refresh]
(c) Writing intelligent function module parameters
Write the set parameters to the CPU module, and reset the CPU module or power off and then on the
programmable controller.
[Online] [Write to PLC...]
Item Description Setting value
Present value Enter the device where the present value is stored. D0
Latch count value Enter the device where the latch count value is stored. D2
Sampling count value
Enter the device where the sampling count value is stored when using the
sampling counter function.
D4
Periodic pulse count previous
value
Enter the device where the previous periodic pulse count value is stored
when using the periodic pulse counter function.
D6
Periodic pulse count present
value
Enter the device where the present periodic pulse count value is stored
when using the periodic pulse counter function.
D8
Sampling/periodic counter
flag
Not used
Overflow detection
Enter the device where the overflow detection result is stored when using
the linear counter function.
D10
Or powering off on the programmble controller