Filter
Top Products
93
Using the Timer Functions
■
Cancelling the timer programming operation
Press TIMER.
STANDBY
Press to specify the timer On time.
When the unit displays the desired time, press
ENTER.
You can also use the number buttons to specify
the time. For example, to program 7:29, press
RECEIVER, then press 0, 7, 2, and 9.
Press +10 to switch AM and PM on the 12-hour
display.
Notes
• When you set the On time, the Off time is
automatically set to an hour later.
• If an MD recorder is programmed to start
recording by a timer, the first few seconds of
the signal may not be recorded. Program the
On time to a value that is about one minute
earlier than the desired On time.
Press to set the timer Off time.
When the unit displays the desired time, press
ENTER.
Turn off the power to place the unit in
Standby mode.
Press STANDBY to place the unit in Standby
mode.
• During timer recording, the unit is muted and
the subwoofer (SWA-155X) is not turned on.
If you wish to audition the sound during
recording, press MUTING to cancel mute
mode. The subwoofer is turned on and you
will be able to hear the sound.
/
/
5
6
Specifying the On time
7
Setting the Off time
Placing the unit in Standby mode.
Notes
• If you wish to record FM or AM analog signals to an MD recorder, be sure to select “Analog
In” for the MD’s recording input source.
• Unless the unit is in Standby mode, the timer will not work at the programmed time. Be sure
to place the unit in Standby mode by pressing STANDBY so that the timer will work.
L-DR7_E.book Page 93 Tuesday, December 24, 2002 3:10 PM