Filter
Top Products
134
Menu Mode [Applicable only when a PDA-5003/PDA-5004 is installed]
15) Orbiter Setting
This function gradually moves the display position of the screen periodically screen position is moved at random,
horizontally or vertically).
Setting ‘MODE1’ to ‘MODE3’ is effective in reducing screen burn when a still image is displayed.
Factory setting: OFF
1 Select ‘OPTION’.
2 Place the cursor on ‘SCREEN MGT.’ then press the [SET]
button.
2 Place the cursor on ‘ORBITER’ then press the [2/3]
buttons to change the settings.
Each time a [2/3] button is pressed, the setting changes
as shown below.
MODE1 ....... The size is reduced so the picture is
completely in the display area.
MODE2 ....... The size is increased so there are no black
bands in the display area.
MODE3 ....... It is displayed at the same size.
Note
• When ‘MODE1’ or ‘MODE2’ has been set, it moves smoothly.
• In ‘MODE3’, it moves in dot units. The entire screen moves one dot horizontally or vertically approximately every
minute. The maximum movement is four dots.
• When it is set to ‘OFF’, the orbiter of the PIP subscreen is ON.
The ‘ORBITER’ setting is common for all inputs.
Screen 2
MENU INPUT1
ENTER
SET
EXIT
MENU
SCREEN SETUP OPTION
LANGUAGE
ENERGY SAVE
TIMER SETTING
SCREEN MGT.
SPLIT FREEZE
AUTO SETUP MODE
AUTO FUNCTION
PIP DETECT
PICTURE
:STANDARD
:INACTIVE
:OFF
:ACTIVE
:ENGLISH
:OFF
Screen 3
SET
SET
EXIT
MENU
SCREEN MANAGEMENT
ORBITER
SOFT FOCUS
: OFF
: OFF
3 OFF
MODE3 2
2
MODE2 2
3
3
3
MODE1
2