Filter
Top Products
149
Integrator Mode
6) Brightness Enhancement (BRT. ENHANCE) Setting at the Center of the Screen
This function improves and enhances the brightness of the center of the screen.
• When emphasizing the brightness of the screen: Set to ON.
• When emphasizing uniformity of the screen: Set to OFF.
Factory setting: OFF
1 Enter the integrator mode.
(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)
2 Select ‘SETUP’.
3 Place the cursor on ‘BRT. ENHANCE’ then press the [SET]
button.
4 Each time a [2/3] button is pressed, the setting changes
as shown below.
Perform the BRT. ENHANCE setting for each input
(INPUT1 to INPUT5).
Also, perform the setting for both PC and video signals.
After setting is complete, press the [SET] button to return
to screen 3.
Note
During video wall, the BRT. ENHANCE function is unavailable,
however, settings can still be changed.
INTEGRATOR INPUT1
ENTER
SCREEN SETUP OPTION
BRT. ENHANCE
SUB VOLUME
PICTURE
SET EXITMENU
:
:
OFF
20
Screen 3
BRT. ENHANCE
:
SET SET EXITMENU
OFF
Screen 4
3
3
ON
OFF 2
2