Filter
Top Products
50 THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
4.5.2 Assembling the mounting hardware and mounting the plasma display
1)Precautions
•Make sure you distinguish correctly between vertical frames for left and right. Both should be mounted so their
hexagonal sockets face outward.
•The horizontal frames should be mounted so their smaller openings face the wall. A total of eight openings are
provided in the horizontal frames for wall-mounting. (A total of fourteen openings are provided in the PDK-5006 itself.)
2)Assembly procedure
1Loosen screw a and separate one end of the hook from the screw.
2Hold the upper part of the vertical frame and open to an approximate width of 10 cm.
3Mount the horizontal frame to the vertical frames.
a
Loosen the screw until you can no longer
see its end through this opening.
a
This surface should face the wall.
This side should face the wall. (The
smaller holes should face the wall.)
Hexagonal
wrench
Positioning the screw with a finger-tip, tighten
the screw with a hexagonal wrench.
Hexagonal sockets
facing outward
THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
Vertical frame (left)
Vertical frame (right)
Horizontal frame
Hexagonal socket head
flange bolt
Hexagonal socket head
flange bolt
Hexagonal
socket head
flange bolt
Hexagonal
socket head
flange bolt
Horizontal frame