Filter
Top Products
96
Screen 1
]
MENU – –
WHITE BALANCE
SCREEN
ADDITIONAL SET UP
3TOTAL INITIALIZE
PICTURE
Screen 2
]
TOTAL INITIALIZE – –
YES23NO
INITIALIZE ?
2
: SEL.
SET : EXIT
Integrator Mode
1 Before entering the Integrator mode, switch the unit to the
input (INPUTs 1-4) with parameters you want to restore to
their initial settings. (Refer to “5.4.1 About Integrator
Mode.”)
For initialization, input signals that would be used in an actual
production run. Make sure that the current color mode is
set to the made in which you want to restore parameters
to factory presets (refer to “5.4.3,” paragraph 4)).
The ID number of the set of items will be indicated in the
upper right corner of the screen, where “– –” is displayed
in the illustration.
Select TOTAL INITIALIZE.
2 Move the cursor to YES using the “2“ button on the remote
or the “-” button on the operating panel of the main unit
and press the SET button. This restores the following
parameters to their factory-preset values and returns the
unit to screen 1:
• PICTURE parameters (refer to “5.4.3,” paragraph 1).)
• WHITE BALANCE parameters (refer to “5.4.3,” paragraph
2).)
• SCREEN parameters (refer to “5.4.3,” paragraph 3).)
9) Initializing Adjustments (TOTAL INITIALIZE)
You can restore adjustments made in the Integrator mode to their factory-preset values. PICTURE, WHITE BALANCE,
and SCREEN parameters (refer to “5.4.3”, paragraphs 1), 2), and 3)) can be restored simultaneously to their initial
settings.
Move the cursor to NO and press the SET button to return to screen 1.
* The following items may not be initialized:
ADDITIONAL SET UP items in Integrator mode • COLOUR MODE
• BAUD RATE
• HOUR METER
• MIRROR MODE
• STD-RGB
• SIDE MASK ADJ.
SET UP items in Menu mode • INPUT SETTING
• SIGNAL
• CLAMP
• ABL
• MP MODE
• 3D Y/C MODE (for U.S. and Taiwanese models)
• COLOUR SYS (for EURO models)
AUTO POWER OFF in Menu mode
V MEMORY in Menu mode