Filter
Top Products
93
6) Mirror Mode
This mode enables you to reproduce incoming images upside down and the left side of the original appearing on the
right and the right side on the left.
(Activated, this mode is, like the colour mode, effective on whichever input function (INPUTs 1-4) is selected.)
This mode is intended for smart cable arrangement, making it possible to draw bundled cables upwards (towards the
ceiling) when this display is mounted upside down using the ceiling hanging hardware PDK-5002.
MIRROR MODE OFF MIRROR MODE-XY
NOTES: • This function is not available when standard rate RGB signals (15.6 kHz x 50 Hz, 15.7 kHz x 60 Hz) are
reproducing (no images would show up).
• In using the PDK-5002 mount kit, observe the operating temperature and other limitations specified under
the heading, 4.4. Plasma display ceiling hanging hardware.
Integrator Mode
Screen 1
]
MENU – –
WHITE BALANCE
SCREEN
3ADDITIONAL SET UP
TOTAL INITIALIZE
PICTURE
Screen 2
]
ADDITIONAL SET UP – –
COLOUR MODE : 1
BAUD RATE : 4800BPS
HOUR METER : 00123
3MIRROR MODE : OFF
EXIT
STD-RGB : OFF
SIDE MASK ADJ.
MAKUHARI
MAKUHARI
1 Enter the Integrator mode (refer to “5.4.1 About the
Integrator Mode”).
The ID number of the set of adjustment items will be
indicated in the upper right corner of the screen, where “–
–” is displayed in the illustration.
Select ADDITIONAL SET UP.
2 Move the cursor to MIRROR MODE and set the mode to
XY or OFF with the SET button.
Pressing the SET button toggles Mirror mode between OFF
and XY.
MIRROR MODE applies to each input (INPUTs 1-4) without
exception. All inputs are immediately switched to XY or OFF
set in step 2.
Select EXIT in screen 2 to return to screen 1.