Filter
Top Products
THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION 53
THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
4)Adjusting the angle
This mounting hardware can be tilted 25 degrees, without set increments. This work should be done by two people.
1Loosen screw c on the left and right vertical frames.
2While sliding the arm down, push the display to the desired angle.
3Once the desired angle is reached, tighten screw c on the left and right frames.
When mounting the display flush or parallel to the wall,
secure the movable and fixed portions of the mount frame
by tightening the screws a, as shown. This prevents
accidental tilting of the display. You must also tighten the
left and right c screws.
c
a
After mounting the unit at an angle, an additional
reinforcement measure can be taken by attaching an
appropriate wire flat bar using screws (a).
Measuring the opening distance x enables approximate
angle values to be determined.
X Angle
181mm 5˚
236mm 10˚
290mm 15˚
341mm 20˚