Filter
Top Products
Network Connection Procedure
English 5
3 Network Operation Screen Display
When the DVR and computer settings are complete, start the Web browser on the computer. The browser should be Internet
Explorer Ver. 5.5 SP2 or higher.
If the computer accesses the DVR following the procedure below, the screen will change to the network operation screen.
1
Enter the connection URL in the address bar
of the browser.
Enter the DVR IP address set in NETWORK SET after
http:// and press the [Enter] key. The authentication
check dialog box will display.
2
Enter the user name and password and then
click .
If the user name and password are entered correctly,
the connection to the DVR will complete and the
language selection screen will display.
3
Select a display language from the network
operation screen and click .
The screen will switch to the main screen and network
operations from the computer will be enabled.
Language selection:
English, French, German, Spanish
When PORT is set to a different value from the
initial "80" append a colon (:) and a PORT
number after the IP address.
<Example when setting PORT to 81>
http://192.168.0.1:81/
• There is no distinction between uppercase and
lowercase.
• If [Remember my password] is checked after
entering the user name and password, entering
the password when connecting can be omitted
the next and subsequent times.
• Because the authentication check dialog box is
displayed when an operation outside the rights is
performed after connecting, it is also possible to
increase the user level while maintaining a
connected state. Cases when there are
restrictions on the connection rights due to
restrictions on the number of simultaneous
connections or network settings are excluded
from this. (Refer to P6)
• Concerning the time setting of the DVR
If the current date and time are not set properly
on the DVR, basic operations such as normal
recording, timer controlled recording, camera
control will not be available. It will also hinder the
setting of other menus related to time and date.
Therefore, please verify whether the current date
and time are properly set on the DVR using the
CLOCK SET screen. (Refer to P24)
• If [NETWORK STATUS] is "ON" in NETWORK
SET of this device when changing to network
operation, the message " NETWORK CONTROL"
will be displayed on the screen of the monitor
connected to the DVR.
• When "Run Time Error" of Java Script
displays while using Internet Explorer
Select the menus in the following order [Tools] →
[Internet Options] → [Advanced Settings] and
then remove the check mark of "Display
notification for each script error" in the browser
settings. Check "Do not use script debugging".
• When a portion of the image is not displayed
due to performance or specifications of the
computer.
Within Internet Explorer select from the menus in
the following order [Tools] → [Internet Option] →
"Temporary Internet Files" and then set [Amount
of disk space to use] to less.