Filter
Top Products
Network Connection Procedure
6 English
bNetwork Connection Restrictions
Connections are restricted depending on the connections
state of users and the content of the network settings. If a
DVR cannot be connected, confirm whether the connection
falls under the following restrictions.
There is a limit to the number of users who can connect
simultaneously.
When a connection is not possible due to restrictions on the
number of simultaneous connections, the message "THE
UNIT IS BUSY!" will display.
1 Up to four users can connect simultaneously to one
DVR.
2 Only one user of either ID2 or ID3 can connect.
3 When a connection is duplicated, the user with the
higher user level will take precedence.
Example:
• If an ID1 user attempts to connect at the same time
as four other ID1 users, the connection will not be
allowed.
• If an ID2 user attempts to connect at the same time
as four other ID1 users, the ID1 user who connected
last will be disconnected and the ID2 user will be
allowed to connect in the ID1 users' place.
• If an ID3 user attempts to connect at the same time
as three other ID1 user and an ID2 user, since ID2
and ID3 users are not able to connect simultaneously,
the ID2 user will be disconnected and the ID3 user
will be allowed to connect in the ID2 user's place.
Connection is restricted by the [NETWORK CONTROL]
settings of NETWORK SET of the DVR.
When a connection is not possible due to operation
restrictions established by NETWORK SET or the operating
state of the DVR, the message "THE UNIT IS NOT
READY!" will display.
1 When "ON (NETWORK)" is selected.
• All users (ID1 to ID3) can connect.
• Cannot connect during DVR playback, camera
control, and while displaying menu screens.
2 When "ON (DVR)" is selected.
• Only user level ID1 can connect. Only monitoring of live
video on the computer is possible.
• Cannot connect while the DVR is in playback
operation.
• If the playback operation is performed by the DVR
when connected, the connection will be automatically
disconnected.
3 When "OFF" is selected.
Cannot connect to DVR.
bChange to DVR Operation
If the disconnect button on the operation panel is clicked,
the network connection will disconnect and the DVR can be
operated.
When the connection is disconnected, the message "THE
UNIT IS DISCONNECTED!" will display.
Restrictions on the number of simultaneous
connected users
Restrictions determined by network settings
• If the browser is closed without clicking the
disconnect button, approximately 1 minute
will pass until reconnecting.
• When [NETWORK CONTROL] of NETWORK
SET of the DVR is set to "ON (NETWORK)",
press the [EXIT/OSD] button for at least 2
seconds. The connection can be forcibly
disconnected from the DVR. The connection
will not be accepted from the computer for 10
seconds after a forced disconnect.
• When communication with the computer is
cut off for approximately 1 minute or more,
the connection will automatically disconnect
and switch to DVR operation.
• The connection will automatically disconnect
when the settings of NETWORK SET of the
DVR are changed while connected.
Disconnect
button
EXIT/OSD