Filter
Top Products
M102E/M501 TRS PREFACE
(Addendum to M101E Manual - P/N 04740 Rev A)
1. PREFACE
NOTE
The information contained in this addendum is pertinent to M102E analyzers running
software revision A.2. Some or all of the information may not be applicable to previous
revision of that software.
The software revision your analyzer is running is displayed in the upper left-hand
corner of the display any time the instrument is in SETUP mode.
This addendum is based on the Model 101E Operators Manual (P/N 04740, REV. A). In most ways
the M102E is identical to the M102E in design and operation, therefore most of the basic set up
information, operating instructions as well as calibration, maintenance, troubleshooting and repair
methods are found in that manual.
This addendum documents only those areas where the M102E is different in design or operating
method from the M102E.
Specifically:
• Areas where updates and improvements to the M10XE software have been implemented
since the publication date of the M101E Manual - P/N 04740 Rev A.
• Corrections of errors and omissions discovered in the M101E Manual - P/N 04740 Rev A.
• EXTERNAL TRS CONVERSION: Like the M101E, which converts H
2
S to SO
2,
then
measures the amount of SO
2
present using a UV fluorescence technique, the M102E
converts total reduced sulfur (TRS) gases into SO
2
before measuring the SO
2
using the
same UV fluorescence method.
Unlike the M102E, which performs the H
2
S Æ SO
2
conversion internally, the M102E
requires an external TRS converter, in this case a Teledyne Instruments M501-TRS.
Therefore this addendum includes instructions and information regarding:
• Areas of operation and setup of the M102 that depart from the method described by
the M101E operator’s manual because the TRS Æ SO
2
conversion is performed
externally.
• The proper set up and operation on the M501-TRS.
05514 Rev A1 1