Record of Manual Revisions
Revision Date Description of Revision
~ 07/2006 Initial Release
©2006 Danaher Motion - All rights reserved. Printed in the USA.
NOTICE:
Danaher Motion
®
is a registered trademark of the Danaher Corporation. Danaher Motion makes every
attempt to ensure accuracy and reliability of the specifications in this publication. Specifications are
subject to change without notice. Danaher Motion provides this information "AS IS" and disclaims all
warranties, express or implied, including, but not limited to, implied warranties of merchantability and
fitness for a particular purpose. It is the responsibility of the product user to determine the suitability of
this product for a specific application.
Safety Symbols
WARNING
Warnings alert users to potential physical danger or harm. Failure to follow warning notices could
result in personal injury or death.
CAUTION
Cautions direct attention to general precautions which, if not followed, could result in personal
injury and/or equipment damage.
NOTE
Notes highlight information critical to your understanding or use of the product.
Safety
WARNING
READ these instructions before connecting power. Damage can result from MISWIRING
at the power terminals.
DANGEROUS voltages are present on power input and motor output terminals.
Only qualified personnel are permitted to transport, assemble, commission, and maintain this equipment. Properly qualified
personnel are persons who are familiar with the transport, assembly, installation, commissioning and operation of motors, and
who have the appropriate qualifications for their jobs.
Read all available documentation before assembling and using. Incorrect handling of products described in this manual can
result in injury and damage to people and/or machinery. Strictly adhere to the technical information regarding installation
requirements.
Keep all covers and cabinet doors shut during operation.
Be aware that during operation, the product has electrically charged components and hot surfaces. Control and power
cables can carry a high voltage, even when the motor is not rotating.
Never disconnect or connect the product while the power source is energized.
After removing the power source from the equipment, wait at least 5 minutes before touching or disconnecting sections
of the equipment that normally carry electrical charges (e.g., capacitors, contacts, screw connections). To be safe,
measure the electrical contact points to each other and to electrical safety earth with a meter before touching the
equipment.
