Filter
Top Products
Page 112
Chapter 5
Referenc e
ON-SCREEN MESSAG ES
Note: Here we list on-screen m essages in message number order. Just find the m essage number in the
upper right-ha nd corner of the message, a nd then find the sam e num ber on the Left-hand side of this
table.
Message
Number
What’s Wrong What You Can Do
001
Maybe there’s a problem with the
multi-dish switch.
• Check the cables and their connections to and from the multi-dish
switch.
• M ake sure all the cables are in place, and their connections are tight.
• If this doesn’t work, call the Customer Service Center for help.
002
• Heavy rain, snow, or cloud cover
can interfere with the satellite signal.
• M aybe there’s other interference.
• Check the local weather. Brush any snow, leaves, etc.
off the satellite dish.
• Make sure the satellite dish has a clear line of sight to the satellite.
• Check whether branches orleaves have grown into the line ofsight.
• Make sure you aim the satellite dish at the satellite. Check the strength
of the signal with the Point Dish/Signal menu.
• If this doesn’t work, call the Customer Service Center for help.
003, 004
• Maybe your system uses the wrong
kind of cable, or maybe the cable run
is too long.
• Maybe there’s a problem with the
multi-dish switch.
• Make sure your system uses RG 6 cable.
•SeeChapter 4, Installation Instructions for the proper cable length for
your system.
• Check the cables and their connections to the multi-dish switch.
Make sure all the cables are in place, and their connections
are tight.
• If this doesn’t work, do the Check Switchtest. See the installation
instructions for what to do.
• If this doesn’t work, call the Customer Service Center for help.
005
Maybewe haven’tyetlinkedthereceiver
with the Smart Card, via the satellite
signal.
• If you’ve called the Customer Service Center to order your program
packages, wait a few minutes to see if the message goes away.
If it doesn’t goes away, call the Customer Service center.
• Try resettin g the receiver using the front pa nel POWER button.
•Ifyouha ven’tcalled theCustomerServiceC entertoorderyourprogram
packages, do so.
006, 007,
008
• Maybe you haven’t connected the
receiver to an active telephone line.
• Maybe you’ve gone over the Smart
Card credit limit.
• M aybe the receiver is connected to a
DSL (digital Subscriber Line) phone
line.
•Youmust connect the receiver to a phone line at all times.
If you install two or more receivers, do this for each receiver.
• Review what you’vebought with payp er vi ew to checkthe Smart Card
credit limit. If you’ve gone over the limit, call the Customer Service
Cente r.
• If this doesn’t work, call the Customer Service Center for help.
• Install a DSL filter between the receiver and the telephone wall jack.
011, 012
In some areas you can’t watch some
programs. For example, if you live close
to a football stadium you can’t watch
football games played there.
• Remember, the program providers decide which programs
they “black out,” notDISH Network.
013, 014
Maybe you tried to tune to a program
on a channel you haven’tbought.
You must buy a channel before you can tune to a program onthat channel .
Call the Customer Service Center( at 1-800-333-DISH [3474])to buy a
channel, or if you think the receiver displayed this message by mistake.
Waituntilbadw eatherconditionshavecleared so thatyourrecei vercanget
the authorization from the satellite.