Filter
Top Products
Page 119
Test the System
TEST THE SYSTEM
START ANY TEST
1. Press the MENU button.
2. Select the
System Setup option.
3. Select the
Diagnos tics option.
Note: “Diagnostics” are just “ tests.”
4. Select the option for the test you want to do.
Note: If we upgrade the r eceiver software ,we m ay a dd new tests.
TEST THE PHONE CONNECTION
1. Make sure you connect a phone line to the receiver’s back pa nel
PHONE JACK.
2. Select the
Connection option.The receiver
displays a m essage that asks you to wait until
the test is done.
• If the phone c onnection is oka y, the receiver displays a
message that says so.
• If the receiver displa ys a message that
it needs to make a toll-free call to the
Customer Service Center, select the
Dial Out option.The receiver displays
a message that asks you to wait until
it finishes the call. When the receiver finishes the call, select
the
Cancel option.
• If you didn’t connect the phone line right, the receiver
displays a message that says so. C he ck the phone connection
andthendothetestagain.
Note: If you have a Digital Subscriber Line (DSL), you may
need to install a DSL filter between the receiver and the
tele phone wall jack, and then do the test again.