Filter
Top Products
Chapter 2
Page 26
Parts of the System
Change the Address
Because UHF signals travel long distances and go through walls, a
neighbor’s remote could control your receiver by m istake. To handle this
problem, you can change the a ddress on the remote a nd receiver as follows:
1. Make sure you turn on the TV and receiver.
2. Open the
Important System Information menu by
pressing the receiver’s front panel SYS INFO button.
3. The
Important System Information menu shows a
Remote Add ress.
Write down this number:
4. Press and hold the SAT mode button a bout three seconds, until
all the mode buttons light up, and then let go of the SAT button.
5. Use the num ber buttons to enter any num ber from 1 to 16, but
not the one you wrote in step 3.
Write down the number you enter:
6. Press the POUND (#) button. If you entered the address correctly, the
SAT mode button flashes three times.
7. Press the RECORD button.
8. Make sure the
Remote Address you se e on the Important System
Information
menu now is the sa me as the one you entered in step 5. If
the addresses are not the same, rep eat step 7.
9. To check the address in the remote control, pre ss and hold the SAT
mode button for three seconds. Then, let go of the SAT button, and
press the P OUND (#) button twice. The SAT mode button flashes the
same number of tim es a s the address you entered in step 5.
Press the SELECT button to close the
Important System Information
menu.