Filter
Top Products
Page 88
Chapter 4
Installation Instructions
below. Be sure there are no multi-dish switches between the LNBF and the
receiver.
10. Attach the LNBF to the Y-bracket using the two LNBF screws.
11. Slide the dish assembly down onto the m ast. Make sure the pivot bolt rests
on the top of the mast. Turn the dish asse mbly so that it points in the ge neral
direction of the satellites, using the azimuth angle from 84.
12. You should see the
Point D ish/Signal menu. If not, open the Main Menu,
select System Setup,thenInstallation,thenPoint Dish/S ignal (press
MENU andthenpress6-1-1 on the remote).
13. Select
Check Swi tch.TheCheck Switch screen will open.
14.
Select Check or Test. The receiver shows you a message that it is checking
the switches. Go to step 15.
15. When the check switch procedure finishes, you will see an installation
summary scre en similar to the one below. In the Satellite line, you will se e
“Conn.” In the Device line, you will “Twin” twice. This indicates that your
receiver has confirmed the connection with your DishPro Twin LNBF is
working. The Transponder line may show two “Xs.” This is OK and does
not indicate a pr oblem with the receiver.
Connect to Port 1. It’son
the left when the LNBF is
pointed towards y ou
Port 1
Port 2