Filter
Top Products
Page 86
Chapter 4
Installation Instructions
4. Assemble the satellit e dish as shown below, except do not attach the Y-
bracket or LNB F a t this time.
5. Loosen both skew bolts and set the skew by rotating the dish m ounting
bracket to align the red mark with the required angle on the skew scale
which you wrote down on 84. Tighten the skew bolts securely to keep the
dish from rotating. Once the skew is set, do not try to fine-tune this angle
when aiming t he dish.
6. Set the elevation by tilting the dish m ounting bracket to align the red edge
with the required angle from page 84 on the elevation scale. Tighten the
elevation bolts, but do not tighten the pivot bolt at this time.