Filter
Top Products
Setting Up
Setting Up 19
3
Insert the cable clamp (A) from the box into the
hole on the back of the TV.
4 Route the cords through the cable clamp, and
bundle the cords in the cable tie (B) from the box.
5 Connect the power cord to the AC power
outlet (C).
Removing or attaching the
stand
Your TV comes with a stand attached to the display.
Use the steps below to remove the stand. Reverse these
steps to attach the stand.
Before removing the stand, unplug the AC cord from
the wall and the AC input.
1 Locate a 3/16-inch (5 mm) Allen wrench to use
during disassembly of the stand.
The stand consists of two pieces, the base and the
pedestal. Four short screws inserted through the
bottom of the base secure the base to the
pedestal. Four long screws through the back of the
TV secure the stand to the TV. You use the Allen
wrench to loosen or tighten the screws.
2 Carefully place the TV with the glass screen facing
downward on a padded, stable table. Position the
TV flat with the stand over the edge of the table.
3 Loosen the four long screws securing the stand
through the back of the TV using the Allen wrench.
Remove the screws.
c
CAUTION: Use two people to disassemble
the TV from the stand.
A
B
C
w
WARNING: Do not drop the stand onto the
TV panel.