Filter
Top Products
Using the Remote Control
Using the Remote Control 43
Programming the device code
using auto setup mode
If your device does not respond to the remote control
after trying all codes listed for your brand, try
searching for your code using these steps for auto
setup mode.
1 Turn on the TV. Turn on the device you would like
to program.
2 Press Device button on the remote control as
needed to select AUD, STB, or DVD that you want
to program.
3 Hold down Device button on the remote control
for 5 seconds until the device light blinks, and
then release the device button. The device light
blinks one more time and then remains lit
indicating the remote control is in programming
mode.
4 Enter 1, 1, 1, 1, and the device light blinks once
and then remains lit.
5 Aim the remote control at the device. Press and
release the Power button once on the remote
control. Wait until the device light stops blinking.
■ If the device turns off, continue with step 6.
■ If the device does not turn off, continue to
press and release the Power button, waiting
each time for the device light to stop blinking,
until the home entertainment device turns off.
6 Once the home entertainment device turns off,
press the OK button on the remote control to save
the code.
n
Each time you press the Power button, the
auto setup is trying a different code. Be
sure to wait until the device light stops
blinking before pressing the Power button
again. You may need to press the Power
button several times before the correct
code is found.